Description
Includes:
- False bottom
- Malt pipe
- Wire support
- Malt pipe handle
- Malt pipe bottom screen
Installation & Use:
- Place the false bottom inside the kettle
- Install the wire support in the channel located at the top of the kettle
- Place the mesh screen inside the malt pipe and attach the handle
- Lower the malt pipe into the kettle so it rests on the wire support
- Calculate and add strike water (Around 3 gallons on a 10lb grain bill). Heat to desired strike temperature
- When desired temperature is reached, turn off the 1000 watt element, add grain and stir until well mixed
- When your mash is complete, use the handle to lift out malt pipe and rotate 90° so the malt pipe feet sit on the wire support
- Allow the wort to drain into the kettle and sparge the grain with warm water (165-175°F) until you have collected enough wort
- When you’re done collecting your wort, remove the malt pipe and proceed to boil with both elements.
CAUTION: Kettle parts become hot during use. PLEASE NOTE: Only the 500-watt element should be used to increase mash temperatures when the Malt Pipe is in place. Using the higher watt element(s) with the Malt Pipe inserted may cause scorching of the grain.
Kegland Part Number: KL12980
Reviews
There are no reviews yet.